Transparency note
This is a representative application study based on PPC capabilities and common specification inputs. It is not presented as a named customer project or as a claim of a specific measured customer outcome.
Component
Copper or aluminum busbars used in switchgear and power-distribution assemblies.
Technical approach
- 01Confirm busbar material and drawing
- 02Define masking and contact zones
- 03Apply the approved dielectric epoxy system to the required coverage
- 04Control film build and cure around part geometry and thermal mass
Verification plan
- Coverage and masking
- Film thickness where specified
- Cure verification
- Electrical/dielectric acceptance testing when included in the specification